User Tools
electrical:12v:battery_capacity
Differences
This shows you the differences between two versions of the page.
| Next revision Both sides next revision | |||
|
electrical:12v:battery_capacity [2017/05/26 19:46] frater_secessus created |
electrical:12v:battery_capacity [2017/05/26 19:49] frater_secessus |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| If you have a 200AH battery bank then C = 200AH. | If you have a 200AH battery bank then C = 200AH. | ||
| - | If the manufacturer recommends max //chargign// at C/5 the rate should be at or below 40A (200/5). \\ | + | If the manufacturer recommends max //charging// at C/5 the rate should be at or below 40A (200/5). \\ |
| - | If the manufacturer recommends max charging at C the rate should be at or below 200A (200/1). \\ | + | If the manufacturer recommends max charging at C((sometimes written as 1C)) the rate should be at or below 200A (1x200). \\ |
| - | Note: the **usual charge rate** for deep cycle batteries is C/10. Sometimes manufacturers express that Absorption stage is complete((and therefore Float should commence)) when the bank is holding Vabs with C/100 or C/200 of current. | + | Note: the **usual charge rate** for deep cycle batteries is C/10. Sometimes manufacturers express that [[electrical: |
| If the manufacturer recommends max // | If the manufacturer recommends max // | ||
electrical/12v/battery_capacity.txt · Last modified: 2022/09/22 12:19 by frater_secessus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
