This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
electrical:12v:battery_capacity [2017/05/26 19:46] frater_secessus created |
electrical:12v:battery_capacity [2017/08/25 21:09] frater_secessus |
||
---|---|---|---|
Line 3: | Line 3: | ||
Battery capacity in Amp-hours is written as **C**. | Battery capacity in Amp-hours is written as **C**. | ||
- | Examples: | + | Note: most deep cycle manufacturer' |
+ | |||
+ | |||
+ | |||
+ | ===== Examples ===== | ||
If you have a 200AH battery bank then C = 200AH. | If you have a 200AH battery bank then C = 200AH. | ||
- | If the manufacturer recommends max //chargign// at C/5 the rate should be at or below 40A (200/5). \\ | + | If the manufacturer recommends max //charging// at C/5 the rate should be at or below 40A (200/5). \\ |
- | If the manufacturer recommends | + | |
- | Note: the **usual charge rate** for deep cycle batteries is C/10. Sometimes manufacturers express that Absorption stage is complete((and therefore Float should commence)) when the bank is holding Vabs with C/100 or C/200 of current. | + | If the manufacturer recommends |
+ | Note: the **usual charge rate** for deep cycle batteries is C/10. Sometimes manufacturers express that [[electrical: | ||
If the manufacturer recommends max // | If the manufacturer recommends max // | ||
- | Note: most deep cycle manufacturer' | + | |