This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
electrical:12v:deep_cycle_battery [2018/12/28 09:47] frater_secessus [Non-LiFePO4 lithium-ion] |
electrical:12v:deep_cycle_battery [2019/10/01 12:54] frater_secessus [lithium chemistries] |
||
---|---|---|---|
Line 147: | Line 147: | ||
===== lithium chemistries ===== | ===== lithium chemistries ===== | ||
+ | |||
+ | Lithium battery banks are lighter and have higher energy density than lead-acid batteries. | ||
+ | |||
+ | |||
+ | Lithium banks come in three main forms: | ||
+ | * " | ||
+ | * DIY banks, often " | ||
+ | * manufactured complete banks that do not mimic the physical shape of lead batteries | ||
+ | |||
+ | ==== BMS ==== | ||
+ | Because of the very high energy density and sensitivity to temperature and voltage extremes, most Li banks are equipped with a Battery Management System (BMS) which monitors and controls the bank and the cells in it. | ||
+ | |||
+ | Depending on the BMS, features may include: | ||
+ | * protection from overcharging individual cells | ||
+ | * "top balancing" | ||
+ | * protection from over-discharge | ||
+ | * protection from excess current in charging and/or discharging | ||
+ | * prevention of charging when temps are too low((typically freezing or below) | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
==== LiFePO4 ==== | ==== LiFePO4 ==== | ||
+ | [[https:// | ||
+ | In theory **LifePO4 (LFP) lithium batteries** should be near perfect for boondockers who [[camping: | ||
+ | |||
+ | [[https:// | ||
- | In theory **LifePO4 lithium batteries** should be near perfect for boondocking. | ||
Line 169: | Line 195: | ||
* can be damaged by heat | * can be damaged by heat | ||
- | For best life (and to decrease the likelihood of cell imbalance) Charge to 13.8v and disconnect voltage at 12.6v.((http:// | + | BMS-equipped LFP banks should be charged according to manufacturer' |
+ | |||
+ | |||
- | The batteries can be charged with either a [[electrical: | ||
- | Technomadia charge to 14.2v, use a minimal " | ||
Further reading: | Further reading: | ||
Line 185: | Line 212: | ||
- | There are hobbyists who build 4S packs and undercharge the cells to only 3.7v. This gives an operating range of 14.8v - 12v, a much better fit for nominal 12v systems. The downside is this configuration only uses 58% of the cells' capacity and will require more cells to achieve the same amount of Ah. | + | There are hobbyists who build **4S packs** and undercharge the cells to only 3.7v. This gives an operating range of 14.8v - 12v, a much better fit for nominal 12v systems. The downside is this configuration only uses 58% of the cells' capacity and will require more cells to achieve the same amount of Ah. |
**7S builds** make a decent **24v bank**. | **7S builds** make a decent **24v bank**. | ||
Line 199: | Line 226: | ||
**Con:** | **Con:** | ||
* overcharging or physical damage can cause a runaway condition (ie fire) | * overcharging or physical damage can cause a runaway condition (ie fire) | ||
- | * voltage mismatch | + | * voltage mismatch |