This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
electrical:12v:directcharginglfp [2024/06/04 14:36] frater_secessus [testing phase] |
electrical:12v:directcharginglfp [2024/06/10 16:37] frater_secessus [reasons NOT to attempt direct charging] |
||
---|---|---|---|
Line 273: | Line 273: | ||
If the SoC was very low (near cutoff) the combiner would slightly faster, ~7.5 minutes. | If the SoC was very low (near cutoff) the combiner would slightly faster, ~7.5 minutes. | ||
- | ===== reasons NOT to attempt | + | ===== reasons NOT to direct |
Line 316: | Line 316: | ||
- make the first test run a brief one and with the Li well-charged.((higher states of charge will reduce current demand)) | - make the first test run a brief one and with the Li well-charged.((higher states of charge will reduce current demand)) | ||
- if solar or other charging source is present, disconnect those chargers and repeat #1.((other chargers will push up apparent bank voltage, which would decrease current demanded of the alternator)) | - if solar or other charging source is present, disconnect those chargers and repeat #1.((other chargers will push up apparent bank voltage, which would decrease current demanded of the alternator)) | ||
- | - repeat steps with the Li bank at lower and lower states of charge, down to the lowest state of charge you expect to recharge from alternator. | + | - repeat steps above with the Li bank at lower and lower states of charge, down to the lowest state of charge you expect to recharge from alternator. |