User Tools

Site Tools


electrical:12v:directcharginglfp

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
electrical:12v:directcharginglfp [2024/06/04 14:36]
frater_secessus [testing phase]
electrical:12v:directcharginglfp [2024/06/20 18:12]
frater_secessus [addendum: other charging reports]
Line 273: Line 273:
  
 If the SoC was very low (near cutoff) the combiner would slightly faster, ~7.5 minutes.  If the SoC was very low (near cutoff) the combiner would slightly faster, ~7.5 minutes. 
-===== reasons NOT to attempt direct charging =====+===== reasons NOT to direct charge LFP =====
  
  
Line 316: Line 316:
   - make the first test run a brief one and with the Li well-charged.((higher states of charge will reduce current demand))  Start the engine and see if the charging current((per the BMS, [[electrical:12v:battery_monitor|battery monitor]], or [[https://amzn.to/3Vt8Jhh|clamp meter]])) and voltage is acceptable.  Check to see chassis voltage and engine RPM remain stable((do not drop precipitously anything longer than a moment while alternator output adjusts)) and belts do not squeal.  Turn off the engine.   - make the first test run a brief one and with the Li well-charged.((higher states of charge will reduce current demand))  Start the engine and see if the charging current((per the BMS, [[electrical:12v:battery_monitor|battery monitor]], or [[https://amzn.to/3Vt8Jhh|clamp meter]])) and voltage is acceptable.  Check to see chassis voltage and engine RPM remain stable((do not drop precipitously anything longer than a moment while alternator output adjusts)) and belts do not squeal.  Turn off the engine.
   - if solar or other charging source is present, disconnect those chargers and repeat #1.((other chargers will push up apparent bank voltage, which would decrease current demanded of the alternator))   - if solar or other charging source is present, disconnect those chargers and repeat #1.((other chargers will push up apparent bank voltage, which would decrease current demanded of the alternator))
-  - repeat steps with the Li bank at lower and lower states of charge, down to the lowest state of charge you expect to recharge from alternator.+  - repeat steps above with the Li bank at lower and lower states of charge, down to the lowest state of charge you expect to recharge from alternator.
  
  
Line 363: Line 363:
 ===== addendum:  other charging reports ===== ===== addendum:  other charging reports =====
  
-This info has been moved to the Other Reports tab on [[https://docs.google.com/spreadsheets/d/145Mx0DQkUbznaiGdTcYmKEc3AqOL3Eu79hqQuzh83oM/edit?usp=sharing|the main spreadsheet]]+This info has been moved to the Other Reports tab on [[https://docs.google.com/spreadsheets/d/145Mx0DQkUbznaiGdTcYmKEc3AqOL3Eu79hqQuzh83oM/edit?usp=sharing|the main spreadsheet]]  It includes setups that lack incomplete info, or interesting related setups. 
electrical/12v/directcharginglfp.txt ยท Last modified: 2024/06/20 18:12 by frater_secessus