This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
electrical:12v:lvd [2017/05/07 16:30] frater_secessus [Low Voltage Disconnect (LVD)] |
electrical:12v:lvd [2018/06/23 16:37] frater_secessus [common LVD setpoints] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Low Voltage Disconnect (LVD) ====== | ====== Low Voltage Disconnect (LVD) ====== | ||
- | A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage. | + | A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage |
- | In most installations | + | The simplest way to implement an LVD is to wire all loads go through |
+ | * a stand-alone LVD with higher current rating (more expensive) | ||
+ | * or run loads off a [[electrical: | ||
+ | |||
+ | except the [[electrical: | ||
===== common LVD setpoints ===== | ===== common LVD setpoints ===== | ||
- | Lead-acid deep cycle batteries last the longest with best capacity if they are never cycled more than 50% [[electrical: | + | Lead-acid deep cycle batteries last the longest with best capacity if they are never cycled more than 50% [[electrical: |
+ | |||
+ | This following chart((http:// | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | The sweet spot appears to be 20-40% DoD, depending on manufacturer. | ||
+ | |||
+ | |||
[[electrical: | [[electrical: | ||
+ | ===== challenges ===== | ||
+ | LVD rely on measured voltage to know when to disconnect, but heavy loads can distort that reading. |