This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
electrical:12v:lvd [2017/05/28 16:49] frater_secessus [common LVD setpoints] |
electrical:12v:lvd [2017/10/25 07:19] frater_secessus [Low Voltage Disconnect (LVD)] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Low Voltage Disconnect (LVD) ====== | ====== Low Voltage Disconnect (LVD) ====== | ||
- | A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage. | + | A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage |
- | In most installations | + | The simplest way to implement an LVD is to wire all loads go through |
+ | * a stand-alone LVD with higher current rating (more expensive) | ||
+ | * or run loads off a [[electrical: | ||
+ | |||
+ | except the [[electrical: | ||
===== common LVD setpoints ===== | ===== common LVD setpoints ===== |