This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
electrical:12v:lvd [2020/10/11 19:48] 127.0.0.1 external edit |
electrical:12v:lvd [2020/11/20 16:15] frater_secessus [Low Voltage Disconnect (LVD)] |
||
---|---|---|---|
Line 3: | Line 3: | ||
A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage (Vlvd). | A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage (Vlvd). | ||
- | The simplest way to implement an LVD is to wire all loads go through the LOAD output of the charge controller, and set the controller' | + | The simplest way to implement an LVD is to wire all loads go through the LOAD output of the charge controller, and set the controller' |
- | * a stand-alone LVD with higher current rating (more expensive) | + | |
- | * or run loads off a [[electrical: | + | |
+ | If the controller has no LVD (ie, no LOAD output) you can use a | ||
+ | |||
| | ||
+ | |||
===== common LVD setpoints ===== | ===== common LVD setpoints ===== |