User Tools
electrical:solar:nonessential
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
electrical:solar:nonessential [2020/07/08 14:49] frater_secessus [charge controller] |
electrical:solar:nonessential [2020/07/08 14:57] frater_secessus [LVD + timer - eternal Absorption] |
||
|---|---|---|---|
| Line 26: | Line 26: | ||
| ===== timing opportunity loads ===== | ===== timing opportunity loads ===== | ||
| + | |||
| + | The trickiest part of running opportunity loads is running them at the right time so battery charging is not affected. | ||
| + | |||
| + | |||
| + | ==== manual model ==== | ||
| + | |||
| + | |||
| You can start the loads **manually** (ie, start using the power when you have extra). | You can start the loads **manually** (ie, start using the power when you have extra). | ||
| Line 82: | Line 89: | ||
| - set the LVD to just under Vabs, set the timer to the Absorption duration | - set the LVD to just under Vabs, set the timer to the Absorption duration | ||
| + | Similar to the above, this setup looks like: [LVD or controller LOAD output] –> timer –> relay –> load | ||
| ===== uses for opportunity loads ===== | ===== uses for opportunity loads ===== | ||
electrical/solar/nonessential.txt · Last modified: 2023/10/18 19:08 by frater_secessus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
