RV and vandwellers wiki

User Tools

Site Tools

Trace:
opinion:frater_secessus:agm2lifepo4

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
opinion:frater_secessus:agm2lifepo4 [2024/01/27 11:10]
frater_secessus [Can I just drop in the LFP and go?] 		opinion:frater_secessus:agm2lifepo4 [2024/03/23 13:08]
frater_secessus [excess current]
Line 20: Line 20:
     * charging only above freezing 32F/0C     * charging only above freezing 32F/0C
   - what your existing charging system provides (or can be configured to provide).    - what your existing charging system provides (or can be configured to provide). 
-    * chassis voltage((the voltage the alternator provides to the vehicle)) +    * alternator voltage and rating if a [[electrical:12v:alternator|combiner]] or [[electrical:12v:b2b|DC-DC]] is present 
-    * alternator output rating (100A, 130A, etc)((if your alternator is successfully charging AGM then it will likely work fine with Li of similar Ah))+    * [[electrical:solar:charge_controller|solar charging]] (profiles, configurability, output rating,  protections if any) 
 +    * [[electrical:converter|shore power charging]] (voltage, output rating, stages if any)
  
-If the existing system cannot be configured to meet LFP's needs within the  alternator's comfort zone then you are looking at replacing some components. For more specific guidance please share details about your setup, use case, budget, and priorities. +If the existing system cannot be configured to meet LFP's needs within [[electrical:12v:alternator_details#current|the  alternator's comfort zone]] then you are looking at replacing some components. For more specific guidance please share details about your setup, use case, budget, and priorities. 
  
 Note:  **undercharging lithium is not an issue** unless you are running out of power. This is a radical change from lead-battery charging.  Note:  **undercharging lithium is not an issue** unless you are running out of power. This is a radical change from lead-battery charging. 
Line 35: Line 36:
 ==== Will I need a special LFP solar charge controller? ==== ==== Will I need a special LFP solar charge controller? ====
  
-Probably not, assuming your existing [[electrical:solar:charge_controller|controller]] has a profile that meet's the LFP's stated needs, or has [[electrical:solar:charge_controller_setpoints|configurable setpoints]].    +Probably not, assuming your existing [[electrical:solar:charge_controller|controller]] has a profile that meet's the LFP's stated needs, or has [[electrical:solar:charge_controller_setpoints|configurable setpoints]] that you can adjust to meet needs. 
  
  
Line 73: Line 74:
   * 1.0C - typical limit enforced by BMS   * 1.0C - typical limit enforced by BMS
  
-From the battery's point of view, alternator charging rates should probably be ≤0.5C, with 0.4C probably being the sweet spot.  So ≤80A for a 200Ah bank.  From the alternator's point of view, current should be limited to [[electrical:12v:alternator_details#current|what the alternator can comfortably provide]] under expected charging conditions.  +From the battery's point of view, alternator charging rates should be ≤0.5C, with 0.4C likely being the sweet spot.  So ≤80A for a 200Ah bank.  From the alternator's point of view, current should be no greater than [[electrical:12v:alternator_details#current|the alternator can comfortably provide]] under expected charging conditions.  
  
 As the Battle Born quote above suggests, for average LFP banks and average cargo van alternators these criteria will often be met with no reconfiguration.  If the criteria cannot be met then we will need [[electrical:12v:b2b|DC-DC charging]] or some other approach to manipulate voltage and/or current.((diode-based isolator, dedicated second alternator, etc)) As the Battle Born quote above suggests, for average LFP banks and average cargo van alternators these criteria will often be met with no reconfiguration.  If the criteria cannot be met then we will need [[electrical:12v:b2b|DC-DC charging]] or some other approach to manipulate voltage and/or current.((diode-based isolator, dedicated second alternator, etc))
Line 157: Line 158:
  
  
-[Note from secessus:  there is [[https://diysolarforum.com/threads/why-you-cannot-charge-lifepo4-below-0-degrees-celsius.2912/post-199774|some evidence]] that LiFePO4 fares better when cell temps are held to warming temps than just above freezing.  For this reason I warm my bank to 50F.]+[Note from secessus:  there is [[https://diysolarforum.com/threads/why-you-cannot-charge-lifepo4-below-0-degrees-celsius.2912/post-199774|some evidence]] that LiFePO4 fares better when cell temps are held to warmer temps than just above freezing.  For this reason I warm my bank to 50F.]
opinion/frater_secessus/agm2lifepo4.txt · Last modified: 2024/03/23 13:13 by frater_secessus

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International

affilliate disclosure

CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki