User Tools
opinion:frater_secessus:self-heated_lifepo4
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
opinion:frater_secessus:self-heated_lifepo4 [2023/09/03 16:24] frater_secessus [robust charging] |
opinion:frater_secessus:self-heated_lifepo4 [2023/10/17 15:13] frater_secessus [how the approaches work] |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| - allow incoming power only to the internal heaters, typically ~60w | - allow incoming power only to the internal heaters, typically ~60w | ||
| - when cell temps are > | - when cell temps are > | ||
| - | - optional: | + | - optional: |
| This means //warming only happens when charging is present// | This means //warming only happens when charging is present// | ||
| Line 34: | Line 34: | ||
| - | With " | + | With " |
| - | + | ||
| - | In some specific use cases one approach might be better-suited than the other. | + | |
| Line 80: | Line 78: | ||
| * how much charging would I miss out on because the bank is taking only 60w to run the heaters instead of taking everything I can throw at it?; and | * how much charging would I miss out on because the bank is taking only 60w to run the heaters instead of taking everything I can throw at it?; and | ||
| - | * how does this compare to the Wh required to keep the bank above freezing when no charging is present? | + | |
| - | | + | * do I need greater configurability than the built-in heater allows? |
| + | * do I have the interest or ability to DIY? | ||
| ===== further reading ===== | ===== further reading ===== | ||
opinion/frater_secessus/self-heated_lifepo4.txt · Last modified: 2023/10/17 15:13 by frater_secessus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
