electrical:12v:multipoint_charging
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
electrical:12v:multipoint_charging [2025/08/02 15:17] frater_secessus [how to make them cooperate] I=V/R |
electrical:12v:multipoint_charging [2025/10/22 15:12] (current) frater_secessus [gotchas] link to sag |
||
|---|---|---|---|
| Line 63: | Line 63: | ||
| Some of these are observed, and some are theoretical. | Some of these are observed, and some are theoretical. | ||
| - | * the vagaries of voltage sag across the system may result in the various charging sources seeing slightly different voltages and therefore contributing in unpredictable ways.((probably a non-issue as long as the bank is getting properly charged)) | + | * the vagaries of [[electrical: |
| * Multiple non-communicating controllers set up to trigger Float from endAmps((trailing amps)) may enter float early since they are providing only some of the charging current. | * Multiple non-communicating controllers set up to trigger Float from endAmps((trailing amps)) may enter float early since they are providing only some of the charging current. | ||
| * Multiple sources may inadvertently exceed the bank's recommended charging current, or your preferred current. | * Multiple sources may inadvertently exceed the bank's recommended charging current, or your preferred current. | ||
electrical/12v/multipoint_charging.1754147835.txt.gz · Last modified: 2025/08/02 15:17 by frater_secessus
Page Tools
affilliate disclosure | the RVwiki runs on a virtual server from NetCup
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
