electrical:solar:pvwatts_assumptions
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
electrical:solar:pvwatts_assumptions [2025/04/22 17:44] frater_secessus DC-DC |
electrical:solar:pvwatts_assumptions [2025/08/01 15:02] (current) frater_secessus [solar assumptions] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| * flat-mounted((no tilt)), air-gapped panels((mounted with space underneath them to allow [[electrical: | * flat-mounted((no tilt)), air-gapped panels((mounted with space underneath them to allow [[electrical: | ||
| - | * with an unobstructed view of the sky (no [[electrical: | + | * with an unobstructed view of the sky (no [[electrical: |
| * on an MPPT [[electrical: | * on an MPPT [[electrical: | ||
| Line 13: | Line 13: | ||
| ====== DC-DC assumptions ====== | ====== DC-DC assumptions ====== | ||
| - | * 50A DC-DC, which the alterator can power and batteries accept | + | |
| - | * assuming average voltage of 13.0v for Amps-to-Watts conversion. | + | * assuming average voltage of 13.0v for Amps-to-Watts conversion. |
electrical/solar/pvwatts_assumptions.1745343859.txt.gz · Last modified: 2025/04/22 17:44 by frater_secessus
Page Tools
affilliate disclosure | the RVwiki runs on a virtual server from NetCup
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
