User Tools

Site Tools


opinion:frater_secessus:epever

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
opinion:frater_secessus:epever [2023/07/03 12:15]
frater_secessus [tracking crashes]
opinion:frater_secessus:epever [2024/09/06 20:11] (current)
frater_secessus [tracking crashes]
Line 68: Line 68:
 >> I threw out my EPSolar Tracers for the same reason, equal paneling with correct voltages in a test of 3 EP Solar Tracers verses 3 Trace C-40 PWM The old trace units preformed much better. ... [the epever] would slowly sink in PV input volts until reset or maybe 20-30 minutes later would do a full sweep and come up to a decent input voltage. I bought a Classic.....problems gone((https://forum.solar-electric.com/discussion/comment/397055#Comment_397055)) >> I threw out my EPSolar Tracers for the same reason, equal paneling with correct voltages in a test of 3 EP Solar Tracers verses 3 Trace C-40 PWM The old trace units preformed much better. ... [the epever] would slowly sink in PV input volts until reset or maybe 20-30 minutes later would do a full sweep and come up to a decent input voltage. I bought a Classic.....problems gone((https://forum.solar-electric.com/discussion/comment/397055#Comment_397055))
  
 +>> After driving with the Victron DC-DC charger kicking on, the Epever MPPT solar charge controller would act similar to a PWM controller: it would read incoming voltage close to the battery's and drastically reduce incoming amps from what was typical for our setup. Resetting breakers or factory resetting the MPPT and setting it up again would fix it until we drove again.[[https://www.reddit.com/r/vandwellers/comments/1faohib/issues_with_renogy_dcdc_with_mppt/llvjoaa/|source]]
opinion/frater_secessus/epever.1688400954.txt.gz ยท Last modified: 2023/07/03 12:15 by frater_secessus