This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
electrical:12v:b2b [2022/11/11 15:03] frater_secessus [Renogy] |
electrical:12v:b2b [2022/11/11 15:07] frater_secessus [Renogy] |
||
---|---|---|---|
Line 117: | Line 117: | ||
==== Renogy ==== | ==== Renogy ==== | ||
+ | |||
+ | === DCC series === | ||
+ | |||
+ | |||
[[https:// | [[https:// | ||
Line 123: | Line 127: | ||
Note: a [[https:// | Note: a [[https:// | ||
- | === solar+alternator behavior | + | == solar+alternator behavior == |
This device' | This device' | ||
Line 131: | Line 135: | ||
{{http:// | {{http:// | ||
- | === charging examples | + | == charging examples |
Using the above information and a theoretical scenario where we have 15A((~250w of panel under excellent conditions)) of solar charging available during the daytime, an alternator capable of delivering 50A, and a bank able to accept 50A of charging: | Using the above information and a theoretical scenario where we have 15A((~250w of panel under excellent conditions)) of solar charging available during the daytime, an alternator capable of delivering 50A, and a bank able to accept 50A of charging: | ||
Line 143: | Line 147: | ||
Note: some have reported better alternator charging performance with the D+ (smart alternator) wire connected, even with plain alternators. | Note: some have reported better alternator charging performance with the D+ (smart alternator) wire connected, even with plain alternators. | ||
- | === starter battery maintenance behavior | + | == starter battery maintenance behavior == |
> If the service battery is in float charge stage, the starting battery will be charged at the same time. The charging voltage is limited at 13.8V. The charging amperage is limited at 25A.((https:// | > If the service battery is in float charge stage, the starting battery will be charged at the same time. The charging voltage is limited at 13.8V. The charging amperage is limited at 25A.((https:// | ||
+ | |||
+ | |||
+ | |||
==== Kisae ==== | ==== Kisae ==== | ||
[[https:// | [[https:// | ||
Line 254: | Line 261: | ||
>> By default, absorption will not exceed 3 hours to prevent overcharging. | >> By default, absorption will not exceed 3 hours to prevent overcharging. | ||
+ | === Rego series === | ||
+ | |||
+ | [[https:// | ||
+ | [[https:// | ||
+ | |||
+ | * configurable output current - 60A/ | ||
+ | * voltage-sense triggering rather than D+ | ||
+ | * 10-300min boost duration in USER mode | ||
+ | * 120min boost duration still hard-coded in predefined lead-chemistry modes, BUT will drop to Float if output is less than 3A (ie Absorption termination based on endAmps) | ||
+ | [[https:// | ||
==== Redarc ==== | ==== Redarc ==== | ||