User Tools

Site Tools


electrical:12v:battery_capacity

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
electrical:12v:battery_capacity [2017/08/25 21:09]
frater_secessus
electrical:12v:battery_capacity [2017/08/25 21:12]
frater_secessus [Examples]
Line 14: Line 14:
  
 If the manufacturer recommends minimum charging at C/10 the rate should be at or above 20A (200/10). \\  If the manufacturer recommends minimum charging at C/10 the rate should be at or above 20A (200/10). \\ 
-Note: the **usual charge rate** for deep cycle batteries is C/10.  Sometimes manufacturers express that [[electrical:12v:charging|Absorption stage]] is complete((and therefore Float should commence)) when the bank is holding Vabs and charging current has dropped to C/100 or C/200. 
  
 If the manufacturer recommends max //discharge// (load) be 3C the rate should be at or below 600A (3x200). \\  If the manufacturer recommends max //discharge// (load) be 3C the rate should be at or below 600A (3x200). \\ 
  
 +If the manufacturer says that [[electrical:12v:charging|Absorption stage]] is complete when charging current has dropped to C/100 or C/200 then the current to watch for would be 2A (200/100) or 1A (200/200).
  
  
electrical/12v/battery_capacity.txt ยท Last modified: 2022/09/22 12:19 by frater_secessus