Differences

This shows you the differences between two versions of the page.

--- electrical:12v:charging [2019/02/04 13:15]
frater_secessus [equalization]
+++ electrical:12v:charging [2019/04/11 19:50]
frater_secessus [charge-and-stop]
@@ Line 59: / Line 59: @@
 ===== charge-and-stop =====
-[[electrical:solar:charge_controller#shunt_controllers|Shunt chargers]] have a charge-and-stop approach where they:
+[[electrical:solar:charge_controller#shunt_controllers|Shunt]] (on/off) chargers have a charge-and-stop approach where they:
   - charge to [[electrical:12v:hvd|High Voltage Disconnect]] (Vhvd) and stop
   - fall in voltage to a High Voltage Reconnect (Vhvr)
@@ Line 92: / Line 92: @@
-If water levels are below the plates, add enough water to cover the places before equalizing.  Then top off //after// equalization.  Doing so before equalization could result in spillover and loss of electrolyte.
+If water levels are below the plates, add enough water to cover the plates before equalizing.  Then top off //after// equalization.  Topping off before equalization could result in spillover and loss of electrolyte.

RV and vandwellers wiki