User Tools

Site Tools


electrical:12v:charging

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
electrical:12v:charging [2020/05/13 12:17]
frater_secessus [charging while using the 12v system]
electrical:12v:charging [2020/06/10 13:09]
frater_secessus [absorption stage]
Line 1: Line 1:
 [[lifestyle:words_of_wisdom|Words of wisdom]]: “Three stage chargers are easier on your batteries, charge them faster, fuller and help you use less water”((https://handybobsolar.wordpress.com/the-rv-battery-charging-puzzle-2/)) – HandyBob [[lifestyle:words_of_wisdom|Words of wisdom]]: “Three stage chargers are easier on your batteries, charge them faster, fuller and help you use less water”((https://handybobsolar.wordpress.com/the-rv-battery-charging-puzzle-2/)) – HandyBob
 +
 +
 +> A [ [[electrical:shore_power|shore power]] ] charger is a stiff source with unlimited energy and time. Your solar is a very soft source of unknown power and only a few hours to get the job done.  - sunking((https://www.solarpaneltalk.com/forum/off-grid-solar/batteries-energy-storage/299490-bulk-absorb-float-equalize-what-does-it-mean#post299490))
 +
  
 ====== charging deep cycle batteries ====== ====== charging deep cycle batteries ======
Line 53: Line 57:
 Some controllers will allow the user to configure the time or ratio of capacity/current (C///n//).  Sternwake says: Some controllers will allow the user to configure the time or ratio of capacity/current (C///n//).  Sternwake says:
 > If your charge controller only holds [absorption] voltage for an hour or two, that is likely not enough time. As long as [there is a load] and you cycle the battery daily, you could set float voltage to 14.8v((for example - secessus)) [to match absorption] without worry. Only when you stop cycling the battery do you need to return float voltage to more regular 13.2v((for example - secessus)) levels. Premature application of float voltage by automatic charging sources is a battery killer.((http://www.cheaprvliving.com/forums/Thread-Solar-or-Battery-Problem?pid=229883#pid229883)) > If your charge controller only holds [absorption] voltage for an hour or two, that is likely not enough time. As long as [there is a load] and you cycle the battery daily, you could set float voltage to 14.8v((for example - secessus)) [to match absorption] without worry. Only when you stop cycling the battery do you need to return float voltage to more regular 13.2v((for example - secessus)) levels. Premature application of float voltage by automatic charging sources is a battery killer.((http://www.cheaprvliving.com/forums/Thread-Solar-or-Battery-Problem?pid=229883#pid229883))
 +
 +If Absorption cannot be completed in the max amount of time configurable in the controller (due to damaged/old batteries), **charging at the minimum rate and/or at higher voltage may help [[electrical:severe_battery_use|compensate]]**.
 +
 +
  
  
electrical/12v/charging.txt · Last modified: 2023/09/16 12:22 by frater_secessus