This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
electrical:12v:deep_cycle_battery [2019/03/07 17:31] frater_secessus [LiFePO4] |
electrical:12v:deep_cycle_battery [2019/10/01 12:38] frater_secessus [Non-LiFePO4 lithium-ion] |
||
---|---|---|---|
Line 169: | Line 169: | ||
* can be damaged by heat | * can be damaged by heat | ||
- | For best life (and to decrease the likelihood of cell imbalance) Charge to 13.8v and disconnect voltage at 12.6v.((http:// | + | BMS-equipped LFP banks should be charged according to manufacturer' |
+ | |||
+ | |||
- | The batteries can be charged with either a [[electrical: | ||
- | Technomadia charge to 14.2v, use a minimal " | ||
Further reading: | Further reading: | ||
Line 185: | Line 186: | ||
- | There are hobbyists who build 4S packs and undercharge the cells to only 3.7v. This gives an operating range of 14.8v - 12v, a much better fit for nominal 12v systems. The downside is this configuration only uses 58% of the cells' capacity and will require more cells to achieve the same amount of Ah. | + | There are hobbyists who build **4S packs** and undercharge the cells to only 3.7v. This gives an operating range of 14.8v - 12v, a much better fit for nominal 12v systems. The downside is this configuration only uses 58% of the cells' capacity and will require more cells to achieve the same amount of Ah. |
**7S builds** make a decent **24v bank**. | **7S builds** make a decent **24v bank**. |