User Tools
electrical:12v:directcharginglfp
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
electrical:12v:directcharginglfp [2022/10/28 10:44] frater_secessus [assessing your own setup for direct alternator charging] vehicle loads |
electrical:12v:directcharginglfp [2022/10/28 10:45] frater_secessus [assessing your own setup for direct alternator charging] |
||
|---|---|---|---|
| Line 208: | Line 208: | ||
| - make the first test run a brief one and with the Li fairly well charged.((higher states of charge will typically lessen current demands to some degree))((if you have paralleled batteries you might want to do this step with just one in place to get a feel for the draw.)) | - make the first test run a brief one and with the Li fairly well charged.((higher states of charge will typically lessen current demands to some degree))((if you have paralleled batteries you might want to do this step with just one in place to get a feel for the draw.)) | ||
| - test it with a drive. | - test it with a drive. | ||
| - | - repeat the last two steps with the Li bank at lower and lower states of charge, down to the lowest | + | - repeat the last two steps with the Li bank at lower and lower states of charge, down to the lowest state of charge you expect to recharge from alternator. |
| - disconnect the isolator with a switch when you come to the desired SoC | - disconnect the isolator with a switch when you come to the desired SoC | ||
electrical/12v/directcharginglfp.txt ยท Last modified: 2024/04/04 11:51 by frater_secessus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
