RV and vandwellers wiki

User Tools

Site Tools

Trace:
electrical:12v:drop-in_lifepo4

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
electrical:12v:drop-in_lifepo4 [2024/03/18 13:30]
frater_secessus [sizing the bank] 		electrical:12v:drop-in_lifepo4 [2024/04/12 23:00]
frater_secessus [Charging cut-off]
Line 368: Line 368:
 === testing your isolator with Li === === testing your isolator with Li ===
  
-see [[electrical:12v:directcharginglfp#assessing_your_setup_for_direct_alternator_charging|this section]]+see [[electrical:12v:directcharginglfp#assessing_your_own_setup_for_direct_alternator_charging|this section]]
  
 ==== but that Victron video ==== ==== but that Victron video ====
Line 527: Line 527:
  
 >> For belt-and-suspenders you could add a $10 12v temp controller or NO thermal switch in series [with the disabling method].   Stick the probe (or switch) on the bank and only complete the [disabling ] circuit when the ignition is on **and** measured temp >0C or >2C or whatever you prefer.  >> For belt-and-suspenders you could add a $10 12v temp controller or NO thermal switch in series [with the disabling method].   Stick the probe (or switch) on the bank and only complete the [disabling ] circuit when the ignition is on **and** measured temp >0C or >2C or whatever you prefer. 
 +
 +Note that some chargers have built-in low-temp charging cutoff already.  
  
  
electrical/12v/drop-in_lifepo4.txt ยท Last modified: 2024/04/12 23:02 by frater_secessus

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International

affilliate disclosure

CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki