This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
electrical:12v:lvd [2021/10/04 12:29] frater_secessus [Low Voltage Disconnect (LVD)] |
electrical:12v:lvd [2021/10/04 12:30] frater_secessus [Low Voltage Disconnect (LVD)] |
||
---|---|---|---|
Line 3: | Line 3: | ||
A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage (Vlvd). | A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage (Vlvd). | ||
- | In theory the simplest way to implement an LVD would be to wire all loads go through the [[electrical: | + | In theory the simplest way to implement an LVD would be to wire all loads go through the [[electrical: |
+ | |||
+ | controller LOAD output -> relay -> loads((the LOAD triggers the relay, but actual power comes from the battery bank)) | ||
If the controller has no LVD (or not no LOAD output at all) you can use a | If the controller has no LVD (or not no LOAD output at all) you can use a |