This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
electrical:12v:voltage_sag [2022/03/16 14:00] frater_secessus [voltage sense wire] |
electrical:12v:voltage_sag [2024/03/10 13:58] (current) frater_secessus [networked shunt] |
||
---|---|---|---|
Line 38: | Line 38: | ||
==== adjust charging setpoints ==== | ==== adjust charging setpoints ==== | ||
+ | If your sag is consistent you could adjust your setpoints upwards. | ||
+ | Or if your battery manufacturer offers a range of charging voltages like 14.0v - 14.4v you could configure 14.4v and know it will be ≤14.4v in real conditions. | ||
Line 49: | Line 51: | ||
Example: | Example: | ||
- | Some sense " | + | Some sense " |
Line 57: | Line 59: | ||
Some controllers use networked [[electrical: | Some controllers use networked [[electrical: | ||
- | Example: | + | Examples: |
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
- | ==== calibration ==== | ||
+ | ==== calibration ==== | ||
+ | The controller may also have a **voltage calibration** setpoint. | ||
- | have a voltage calibration setting - sag varies with current so the user might need to figure out average sag in their use case. | + | Unfortunately, |