RV and vandwellers wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Adding voltage-sensing to an ignition-triggered device ======

[[https://amzn.to/2RubQqw|{{ https://m.media-amazon.com/images/I/41r+vV6QMUL._AC_UY218_.jpg}}]]

[[electrical:12v:alternator#isolators|Solenoids]] and some [[electrical:12v:b2b|DC-DC chargers]] use a circuit powered when the ignition is on (IGN) to start their operation.   [[electrical:12v:alternator#voltage-sensing_relays|Voltage-Sensing Relays]] (VSR) do this by reading voltage to know when alternator charging((or some other form of charging)) is occurring.

Voltage-sensing can be added to devices that lack it by adding a [[electrical:12v:lvd|low voltage disconnect]]((no timer delay)), or [[https://amzn.to/2RubQqw|a relay-delay]] to the trigger wire.((https://diysolarforum.com/threads/dc-dc-charger-b2b-options-and-general-discussion.17211/post-250213))  The device on the right is a relay-delay:

> it operates by sensing the voltage on the main 12 volt system. When this voltage goes above 13.3 volts for approximately 12 seconds... it will close the isolator relay providing charging current to the auxiliary battery.((https://rvelectrical.com/product/intellitec-battery-isolator-relay-delay-00-00629-120/))

There are many kinds of [[https://amzn.to/3m2OTp3|12v LVD]], from simple boards to premium examples from [[https://amzn.to/3LL9Y4f|Victron]] and [[https://amzn.to/34Whf0B|Blue Sea]].


Note that these can sense voltage on any circuit, not just the IGN circuit.

RV and vandwellers wiki

User Tools

Site Tools

Page Tools