User Tools

Site Tools


electrical:severe_battery_use

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revision Both sides next revision
electrical:severe_battery_use [2018/03/20 13:12]
frater_secessus created
electrical:severe_battery_use [2019/08/21 21:46]
frater_secessus [limiting the damage]
Line 7: Line 7:
 ===== how low can we go? ===== ===== how low can we go? =====
  
-The most common low-end targets for [[electrical:12v:lvd|low voltage disconnect]] are:+For folks willing to trade battery longevity for some amount of increased capacity, common low-end targets for [[electrical:12v:lvd|low voltage disconnect]] are:
  
 +  * 60% DoD / 40% SoC, ~12.0 rested volts
   * 75% DoD / 25% SoC, ~11.7 rested volts   * 75% DoD / 25% SoC, ~11.7 rested volts
   * 80% DoD / 20% SoC, ~11.6 rested volts   * 80% DoD / 20% SoC, ~11.6 rested volts
- 
-===== limiting the damage ===== 
  
  
  
 +===== limiting the damage =====
  
 +Deep cycles generally extend the amount of time for a battery to complete Absorption.  
  
-Deep cycles generally extend the amount of time for a battery to complete Absorption.  Extend the +  * get power back into the battery ASAP after deep discharge;  drive for alternator charging or run generator to get bulk stage going  
 +  * increase Absorption time, or even set Vfloat == Vabs. 
 +  * if flooded, keep a close watch on water levels
  
  
  
electrical/severe_battery_use.txt · Last modified: 2024/03/30 21:42 by frater_secessus