This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
electrical:solar:charge_controller_setpoints [2017/10/26 21:31] frater_secessus |
electrical:solar:charge_controller_setpoints [2017/10/26 21:47] frater_secessus [load setpoints] |
||
---|---|---|---|
Line 4: | Line 4: | ||
===== charging setpoints ===== | ===== charging setpoints ===== | ||
- | Most charging-related setpoints are // | ||
- | * Absorption voltage (Vabs) - the voltage the battery bank is held at during the absorption stage. | + | |
+ | * **Absorption voltage (Vabs)** - the voltage the battery bank is held at during | ||
+ | * **Absorption duration** - the amount of time Vabs will be held until dropping to Vfloat. | ||
+ | * **Absorption termination** - the amount of current (or percentage of capacity) Absorption must fall to before dropping to Vfloat. | ||
+ | * **Absorption restart** - voltage (or duration) at which Absorption stage after failing to maintain Vfloat | ||
+ | ===== load setpoints ===== | ||
+ | Only present on controllers with LOAD outputs. | ||
- | + | * **Low voltage disconnect (Vlvd)** - voltage at which the controller turns off loads to prevent excessive battery discharge. | |
- | + | * **Low voltage reconnect (Vlvr)** - the setpoint at which the load is turned back on after recovering from Vlvd cutoff. | |
- | ===== load setpoints ===== | + | |