User Tools

Site Tools


electrical:solar:status

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
electrical:solar:status [2017/12/02 04:44]
frater_secessus
electrical:solar:status [2018/12/31 14:04]
frater_secessus [then observe the controller]
Line 9: Line 9:
   - solar is $$$; and   - solar is $$$; and
   - solar can seem magical; and   - solar can seem magical; and
-  - **both poorly running systems and mostly/fully charged systems show low levels of output**+  - both **poorly running systems** and **mostly/fully charged systems** show low levels of output for different reasons
  
 The last point may be counterintuitive.  A **fully charged system** is observed to deliver very little power because the bank is already charged;  the system is loafing, waiting for a load.  It only cranks up power when you add a big load or start charging a depleted battery.  With lead chemistry batteries this also applies in [[electrical:12v:charging#absorption_stage|Absorption stage]], when the battery reduces the amount of current it will accept. The last point may be counterintuitive.  A **fully charged system** is observed to deliver very little power because the bank is already charged;  the system is loafing, waiting for a load.  It only cranks up power when you add a big load or start charging a depleted battery.  With lead chemistry batteries this also applies in [[electrical:12v:charging#absorption_stage|Absorption stage]], when the battery reduces the amount of current it will accept.
Line 46: Line 46:
 ===== then observe the controller ===== ===== then observe the controller =====
  
-These checks are admittedly crude but will help see if your system is getting it done.  No expensive or specialized equipment is required. MPPT controllers in particular will reveal a great deal of information by how they interact with the panels. +These checks are admittedly crude but will help see if your system is getting it done.  No [[electrical:12v:battery_monitor|expensive or specialized equipment]] is required.((but use them if you have them!)) MPPT controllers in particular will reveal a great deal of information by how they interact with the panels. 
  
 For the examples below we will assume the system is set up this way: For the examples below we will assume the system is set up this way:
Line 81: Line 81:
   * Vbatt == Vabs until the controller's criteria for ending absorption is met   * Vbatt == Vabs until the controller's criteria for ending absorption is met
   * Controller output decreasing as current demand drops.   * Controller output decreasing as current demand drops.
-  * **Example:**  Panel voltage 17v and rising, battery voltage held at Vabs == 12.6v, controller output amps 2A and dropping+  * **Example:**  Panel voltage 17v and rising, battery voltage held at Vabs == 14.6v, controller output amps 2A and dropping
  
 **During Absorption charging with PWM** **During Absorption charging with PWM**
Line 87: Line 87:
   * Controller output decreasing as current demand drops.   * Controller output decreasing as current demand drops.
   * the controller may get warmer as current demand drops((percentage of time the PWM circuit is turned OFF increases))   * the controller may get warmer as current demand drops((percentage of time the PWM circuit is turned OFF increases))
-  * **Example:**  Panel and battery voltage held at Vabs == 12.6v, controller output 2A and dropping+  * **Example:**  Panel and battery voltage held at Vabs == 14.6v, controller output 2A and dropping
  
 ==== in float ==== ==== in float ====
electrical/solar/status.txt ยท Last modified: 2024/01/14 15:32 by frater_secessus