User Tools
electrical:solar:status
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
electrical:solar:status [2023/11/19 17:15] frater_secessus [setups with no float] |
electrical:solar:status [2024/01/14 10:46] frater_secessus [setups with no float] link to float to make things easier |
||
|---|---|---|---|
| Line 126: | Line 126: | ||
| Configurations with no float (" | Configurations with no float (" | ||
| - | - charge to the Absorption (" | + | - charge to the Absorption (" |
| - **stop charging** | - **stop charging** | ||
| - until voltage falls to the rebulk (" | - until voltage falls to the rebulk (" | ||
| - repeat | - repeat | ||
| - | The fall to reBulk looks like the transition to Vfloat described above. In both cases the controller makes no (or practically no) power until the lower setpoint is reached. | + | The fall to reBulk looks like the transition to Vfloat |
| === Renogy confusion === | === Renogy confusion === | ||
| Line 145: | Line 145: | ||
| * the manual does not state the 13.2v boost return setpoint [an egregious error - secessus] | * the manual does not state the 13.2v boost return setpoint [an egregious error - secessus] | ||
| - | Users uncomfortable with this behavior can set up the USER profile to meet their needs, including defining [[electrical: | + | Users uncomfortable with this behavior can set up the USER profile to meet their needs, including defining [[electrical: |
electrical/solar/status.txt ยท Last modified: 2024/01/14 15:32 by frater_secessus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
