Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
hvac:heating [2017/10/07 14:24] frater_secessus [off-grid heating] |
hvac:heating [2018/12/18 18:34] frater_secessus [off-grid heating] |
* [[http://amzn.to/2p9A6zk|Big Buddy]] - 400btu, 9000btu, 18,000btu. Oversized for most camper applications. | * [[http://amzn.to/2p9A6zk|Big Buddy]] - 400btu, 9000btu, 18,000btu. Oversized for most camper applications. |
| |
Tip: you can turn the Mr. Buddy down //below// the LOW setting by depressing the gas knob like you are turning it off, then easing the setting back to the desired level. | Tip: you can turn the Buddy down //below// the LOW setting by depressing the gas knob like you are turning it off, then //slowly// easing the setting back to the desired level. The flames will "flutter" a bit if set too low -- increase slightly from that point. |
| |
Tip: you can run the Buddy on just the pilot light; this will emit a small but noticeable amount of heat (~300-500 BTU).((http://www.cheaprvliving.com/forums/showthread.php?tid=21574)) | Tip: you can run the Buddy on just the pilot light; this will emit a small but noticeable amount of heat (~300-500 BTU).((http://www.cheaprvliving.com/forums/showthread.php?tid=21574)) |
| |
It is common to run a standard Buddy heater off the camper's large propane cylinder, perhaps teed off the stove line. Unless [[http://amzn.to/2pUO0Cv|the line is regulated]] an [[http://amzn.to/2pnEXZS|inline "filter"]] (or more properly a "separator"((https://www.amazon.com/review/R2645P9QKIB0IG/ref=cm_cr_rdp_perm?ie=UTF8&ASIN=B000HE8P2O))) is required. This keeps oils leeched out by high pressure from entering the heater and clogging the orifice. | It is common to run a standard Buddy heater off the camper's large propane cylinder, perhaps teed off the stove line. Unless [[http://amzn.to/2pUO0Cv|the line is regulated]] an [[http://amzn.to/2pnEXZS|inline "filter"]] (or more properly a "separator"((https://www.amazon.com/review/R2645P9QKIB0IG/ref=cm_cr_rdp_perm?ie=UTF8&ASIN=B000HE8P2O))) is required. This keeps oils leached out by high pressure from entering the heater and clogging the orifice. |
| |
[[http://amzn.to/2gE3KqV|{{ https://images-na.ssl-images-amazon.com/images/I/51dMW-hZ0nL._AC_US160_.jpg}}]] | [[http://amzn.to/2gE3KqV|{{ https://images-na.ssl-images-amazon.com/images/I/51dMW-hZ0nL._AC_US160_.jpg}}]] |