This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
rv:ford_transit [2022/11/26 04:05] princess_fluffypants [Windows] |
rv:ford_transit [2022/12/06 19:58] princess_fluffypants [Dimensions] |
||
---|---|---|---|
Line 19: | Line 19: | ||
The stock engine is a naturally aspirated V-6 ([[https:// | The stock engine is a naturally aspirated V-6 ([[https:// | ||
- | The Ecoboost engine in all model years of Transits is the Gen1 engine, and does not have the additional enhancements given to the Gen2 engine found in the F-150 and other consumer vehicles. | + | The Ecoboost engine in all model years of Transits is the Gen1 engine, and does not have the additional enhancements given to the Gen2 engine found in the F-150 and other consumer vehicles. |
Auto-Start-Stop (A.S.S) was mandatory on the engines for 2020-2022, but has been dropped for 2023 due to manufacturing delays and chip shortages. | Auto-Start-Stop (A.S.S) was mandatory on the engines for 2020-2022, but has been dropped for 2023 due to manufacturing delays and chip shortages. | ||
Line 75: | Line 75: | ||
The majority of the holes in the cargo area of the van are 9.38mm in diameter, and usually work well with M6 or 1/4-20 rivnuts. Most Rivnuts from Amazon fit fine, but some rivnuts (most notably from McMaster-Carr) are actually slightly too large and need a full 10mm hole. The majority of pre-threaded holes are M8x1.25 thread, with a few being M10x1.5. See video here: https:// | The majority of the holes in the cargo area of the van are 9.38mm in diameter, and usually work well with M6 or 1/4-20 rivnuts. Most Rivnuts from Amazon fit fine, but some rivnuts (most notably from McMaster-Carr) are actually slightly too large and need a full 10mm hole. The majority of pre-threaded holes are M8x1.25 thread, with a few being M10x1.5. See video here: https:// | ||
+ | |||
+ | [[https:// | ||
While some people have been able to use plusnut into the factory holes, most holes will need to be enlarged slightly.((There' | While some people have been able to use plusnut into the factory holes, most holes will need to be enlarged slightly.((There' |