User Tools

Site Tools


electrical:12v:b2b

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
electrical:12v:b2b [2021/05/19 12:11]
frater_secessus [examples - with MPPT]
electrical:12v:b2b [2021/06/18 18:46]
frater_secessus [examples - with MPPT]
Line 52: Line 52:
 ===== examples - with MPPT ===== ===== examples - with MPPT =====
  
-Combining the [[electrical:solar:charge_controller|solar charge controller]] and DC-DC charger in one unit can have benefits in cleaner/simpler installation and perhaps cost over separate components.   The downsides are less configurabilty((you aren't choosing your own highly-configurable components)), single points of failure, and limited options on solar input.  +Combining the [[electrical:solar:charge_controller|solar charge controller]] and DC-DC charger in one unit can have benefits in cleaner/simpler installation, starter battery maintenance from solar, and perhaps cost over separate components.   The downsides are less configurabilty((you aren't choosing your own highly-configurable components)), single points of failure, and limited options on solar input.  
  
 Combo units typically have much **lower maximum panel input voltages** (as low as 23v) than a standalone charge controller would (60v - 150v).  This limits the solar configuration in a few ways: Combo units typically have much **lower maximum panel input voltages** (as low as 23v) than a standalone charge controller would (60v - 150v).  This limits the solar configuration in a few ways:
Line 94: Line 94:
  
   * DCC50S [[https://amzn.to/2QYuswm|50A model with MPPT charging]]. MPPT input limited to 25v.((per the manual)) - [[https://www.renogy.com/content/RBC50D1S-G1/RBC50D1S-G1-Manual.pdf|manual]] (pdf)  Total output is limited to 50A from either independent source (see below).     * DCC50S [[https://amzn.to/2QYuswm|50A model with MPPT charging]]. MPPT input limited to 25v.((per the manual)) - [[https://www.renogy.com/content/RBC50D1S-G1/RBC50D1S-G1-Manual.pdf|manual]] (pdf)  Total output is limited to 50A from either independent source (see below).  
 +
 +Note:  a [[https://amzn.to/3fSFDD2|30A combo model]] is also available
        
 === solar+alternator behavior === === solar+alternator behavior ===
Line 111: Line 113:
   * driving in daytime:  25A alternator + 15A solar = 40A total charging   * driving in daytime:  25A alternator + 15A solar = 40A total charging
  
 +[[https://www.renogy.com/content/RBC3050D1S-G1/RBC3050D1S-Manual.pdf|Behavior is the same for the 30A model]] (pdf) except 15A + 15A //vs// 25A + 25A above. 
  
  
electrical/12v/b2b.txt ยท Last modified: 2024/07/02 19:27 by frater_secessus