Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
electrical:solar:charge_controller [2023/09/06 12:05] frater_secessus [MPPT] |
electrical:solar:charge_controller [2023/09/06 12:23] frater_secessus [MPPT] |
| |
[[https://diysolarforum.com/threads/why-is-mppt-better-than-pwm.24892/post-295861|For technical reasons]] PWM can deliver more current than the panels' Imp, even nearing Isc. | [[https://diysolarforum.com/threads/why-is-mppt-better-than-pwm.24892/post-295861|For technical reasons]] PWM can deliver more current than the panels' Imp, even nearing Isc. |
| |
| === panel selection for PWM === |
| |
| PWM makes the most power when coupled with panels whose operating [[electrical:solar:panels#specifications|Vmp]] is very close to the controller's Absorption ("boost") voltage [[electrical:solar:charge_controller_setpoints|setpoint]]. Since [[electrical:solar:output#panel_temperature|ambient temperatures affect operating Vmp]] the panel's Vmp spec on the label should be about 10% higher than Absorption voltage. |
| |
| Examples: |
| |
| * 16.28v Vmp panel spec would be optimal for 14.8v Absorption, as we might use for flooded lead acid. 14.8v x 1.1 = 16.28v. |
| * 15.62v Vmp panel spec would be optimal for 14.2v Absorption, as we might use for Gel or LiFePO4. |
| |
| |
| Some [[electrical:solar:panels#thin_film|thin-film]] panels have Vmp in that range but most panels are much higher. So we find the lowest Vmp practical. 17Vmp panels would perform better on PWM than 18v or 19v. |
==== MPPT ==== | ==== MPPT ==== |
[[http://amzn.to/2iD3WKf|{{ https://images-na.ssl-images-amazon.com/images/I/51bi9IjcsRL._AC_US160_.jpg}}]] | [[http://amzn.to/2iD3WKf|{{ https://images-na.ssl-images-amazon.com/images/I/51bi9IjcsRL._AC_US160_.jpg}}]] |
| |
There are some considerations when [[electrical:solar:mppt design|designing a system around an MPPT controller]]. | There are some considerations when [[electrical:solar:mppt design|designing a system around an MPPT controller]]. |
| |
| == panel selection for MPPT == |
| |
| MPPT thrives on voltage. In general, we should select panels that have the highest-practical Vmp while staying safely under the controller's voltage input limit. MPPT efficiency tends to be greatest when panel voltage is ~twice the charging voltage. The exact ratio varies by controller so read the docs for specifics. |
| |
| Note that [[electrical:solar:series_vs_parallel|panels can be run in series]] to increase their voltage. |
| |
| |
== when PWM beats MPPT == | == when PWM beats MPPT == |