Differences

This shows you the differences between two versions of the page.

--- electrical:solar:charge_controller [2024/04/16 20:28]
frater_secessus [specs]
+++ electrical:solar:charge_controller [2024/06/01 22:01]
frater_secessus [sensors]
@@ Line 25: / Line 25: @@
 Cautionary example:  [[https://www.youtube.com/watch?v=z5RtZe9AW2E|12W Unregulated Panel vs. 220Ah AGM Bank]]
+==== sensors ====
+To charge correctly the controller needs to know the precise voltage and temperature of the battery bank.
+In the best case scenario these measurements are done with an external **temp sensor** and **voltage sense**((not a typo, it's called voltage sense)) that plug into the controller or talk to the controller via bluetooth.
+In the absence of external sensors the controller tries to use any internal sensors it might have.  The values will be inaccurate:
+  * battery voltage will read [[electrical:12v:voltage_sag|falsely high during charging]], and
+  * temperature will read falsely high because of the heat the controller generates from its own electronics
+With **lead-chemistry batteries** both conditions can cause [[electrical:12v:psoc|chronic undercharging]], a key cause of [[electrical:batterycide|premature battery failure]].  Many **LiFePO4 batteries** have their own [[opinion:frater_secessus:agm2lifepo4#wait_lfp_can_be_damaged_by_charging_in_cold_weather|low temperature charging cutoff]] but those that do not must rely on the charger to disconnect when battery temps are ~freezing.
 ===== specs =====

RV and vandwellers wiki