This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
opinion:solar:sizing.walkthrough [2022/04/20 14:23] frater_secessus [minimum charging current] |
opinion:solar:sizing.walkthrough [2022/04/20 14:49] frater_secessus [minimum charging current] |
||
---|---|---|---|
Line 96: | Line 96: | ||
4,168Wh / 12.0v nominal voltage = **347Ah** of lead-chemistry required. | 4,168Wh / 12.0v nominal voltage = **347Ah** of lead-chemistry required. | ||
+ | Also see the [[opinion: | ||
==== lithium ==== | ==== lithium ==== | ||
Line 144: | Line 144: | ||
* **Kansas in December** - 2, | * **Kansas in December** - 2, | ||
- | ==== minimum charging current ==== | ||
- | |||
- | Lead-chemistry batteries have minimum and maximum charging current specifications. | ||
- | |||
- | Lead acid typically require a minimum of [[electrical: | ||
- | |||
- | * increase our panel and controller to cover it. 34.7A x 12v nominal / 0.85 system efficiency = 490w and a 40A controller. or, | ||
- | * add alternator charging or other high-current source (see below) and let that system blast the batteries from time to time. | ||
- | |||
- | Lithium batteries do not have a minimum charging current spec in the normal sense. | ||
Line 162: | Line 152: | ||
MPPT controllers are more expensive so they often sized to the average solar harvest wattage rather than rated panel wattage. | MPPT controllers are more expensive so they often sized to the average solar harvest wattage rather than rated panel wattage. | ||
- | Example: | + | Example: |
+ | ==== minimum charging current ==== | ||
+ | |||
+ | Note: if your offgrid system will use lead-chemistry batteries and needs to last for years then read this section. | ||
+ | |||
+ | Lead-chemistry batteries have minimum and maximum charging current specifications. | ||
+ | |||
+ | Lead acid battteries typically require a minimum of [[electrical: | ||
+ | |||
+ | * increase our panel and controller to cover it. 34.7A x 12v nominal / 0.85 system efficiency = 490w and a 40A controller.((this is //only// about charging current, not the panel required to charge the batteries fully over time)) A pleasant side effect is the system would make more power (+16%) than we strictly need for charging, so we might be a little looser with power use. Or might do a little better under adverse solar conditions. | ||
+ | * add alternator charging or other high-current source (see below) and let that system blast the batteries from time to time. | ||
+ | |||
+ | Lithium batteries do not have a minimum charging current spec in the normal sense. | ||