User Tools
electrical:12v:battery_monitor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
electrical:12v:battery_monitor [2024/03/29 20:14] frater_secessus [sizing] expanded |
electrical:12v:battery_monitor [2024/10/21 10:43] (current) frater_secessus [TL;DR] |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| [[https:// | [[https:// | ||
| * Battery monitors start from a known State of Charge then count every Amp going into or out of the battery bank | * Battery monitors start from a known State of Charge then count every Amp going into or out of the battery bank | ||
| + | * the shunt can be internal to the battery (lithium batts with BMS comms) or external to the bank | ||
| + | * the current acceptance of the battery bank in Absorption can tell you how close to fully charged a lead battery is((applies to Li also but the numbers are much smaller and we are not chasing 100% necessarily)) | ||
| * these measurements can go astray (" | * these measurements can go astray (" | ||
| * drift will be more noticeable with lead chemistries than lithium | * drift will be more noticeable with lead chemistries than lithium | ||
| Line 85: | Line 87: | ||
| + | * YT: [[https:// | ||
| ==== Bogart Trimetric ==== | ==== Bogart Trimetric ==== | ||
electrical/12v/battery_monitor.1711757657.txt.gz · Last modified: 2024/03/29 20:14 by frater_secessus
Page Tools
affilliate disclosure | the RVwiki runs on a virtual server from Phanes
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
