electrical:12v:battery_monitor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
electrical:12v:battery_monitor [2024/07/12 21:22] frater_secessus [Victron SmartShunt] |
electrical:12v:battery_monitor [2025/12/24 22:58] (current) |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| [[https:// | [[https:// | ||
| * Battery monitors start from a known State of Charge then count every Amp going into or out of the battery bank | * Battery monitors start from a known State of Charge then count every Amp going into or out of the battery bank | ||
| + | * the shunt can be internal to the battery (lithium batts with BMS comms) or external to the bank | ||
| * the current acceptance of the battery bank in Absorption can tell you how close to fully charged a lead battery is((applies to Li also but the numbers are much smaller and we are not chasing 100% necessarily)) | * the current acceptance of the battery bank in Absorption can tell you how close to fully charged a lead battery is((applies to Li also but the numbers are much smaller and we are not chasing 100% necessarily)) | ||
| * these measurements can go astray (" | * these measurements can go astray (" | ||
electrical/12v/battery_monitor.1720819353.txt.gz ยท Last modified: 2025/12/24 22:38 (external edit)
Page Tools
affilliate disclosure | the RVwiki runs on a virtual server from NetCup
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
