This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
rv:diesel [2022/12/12 16:07] princess_fluffypants [Oxides of Nitrogen] |
rv:diesel [2024/07/29 22:39] (current) princess_fluffypants [Oxides of Nitrogen] |
||
---|---|---|---|
Line 9: | Line 9: | ||
===== Applicability ===== | ===== Applicability ===== | ||
- | **This is not a slight against any specific manufacturer**; | + | **This is not a slight against any specific manufacturer**; |
+ | This article is also //not// " | ||
==== Known Good Engines ==== | ==== Known Good Engines ==== | ||
- | These engines were produced before the tightened emissions regulations took effect, and are generally know for being reasonably reliable. Any engines built **after** these known good engines will be problematic. | + | These engines were produced before the tightened emissions regulations took effect, and are reasonably reliable. Any engines built **after** these known good engines will be problematic. |
* **Ford** | * **Ford** | ||
Line 24: | Line 25: | ||
* **Dodge** | * **Dodge** | ||
* High Output Cummins 600 (model year 2004-2006) | * High Output Cummins 600 (model year 2004-2006) | ||
+ | |||
+ | As of 2023, pre-emission diesel vehicles over 14,000lbs GVRW [[https:// | ||
----- | ----- | ||
Line 35: | Line 38: | ||
Unfortunately trying to build a cooler that can withstand 2,200 degree gasses and 200 degree coolant right next to each other has been an engineering nightmare - they are typically made of stainless steel, but over time the coolers inevitably crack and/or plug up. This is a problem with //all// modern diesel engines, on everything from little VW’s to giant semi-truck Cummins ISX engines. When they crack, they result in water squirting into the engine intake which can cause internal engine damage due to the increased pressure when coolant turns to steam. Also, it’s generally a ton of work to change the EGR cooler because of its location, especially in V8 diesels. They also plug up easily because cooling exhaust causes the soot to drop out of suspension and collect everywhere. | Unfortunately trying to build a cooler that can withstand 2,200 degree gasses and 200 degree coolant right next to each other has been an engineering nightmare - they are typically made of stainless steel, but over time the coolers inevitably crack and/or plug up. This is a problem with //all// modern diesel engines, on everything from little VW’s to giant semi-truck Cummins ISX engines. When they crack, they result in water squirting into the engine intake which can cause internal engine damage due to the increased pressure when coolant turns to steam. Also, it’s generally a ton of work to change the EGR cooler because of its location, especially in V8 diesels. They also plug up easily because cooling exhaust causes the soot to drop out of suspension and collect everywhere. | ||
- | Adding [[https:// | + | Adding [[https:// |
===== Exhaust Soot ===== | ===== Exhaust Soot ===== | ||
- | + | ||
- | Diesels put out a ton of soot, this is what gives diesel exhaust its characteristic big black clouds when under heavy load. To get rid of it, manufacturers use a particulate trap that collects the soot and uses extra-injected fuel to burn it away in a process that that can go over 2800 degrees. This works okay in vehicles that are driven hard all the time, like semi-trucks (Well the chambers eventually plug up, but it takes a while). | + | Diesels put out a ton of soot, this is what gave pre-emission |
But passenger vehicles’ light duty cycles don’t allow for automatic burning, so sometimes they have to perform forced burn cycles when the vehicle is parked. This uses a ton of extra fuel and upsets the owner, who doesn’t understand why their vehicle is running at a fast idle by itself and has superheated exhaust pouring out the back. Some early light trucks actually caught their plastic rear bumpers on fire. | But passenger vehicles’ light duty cycles don’t allow for automatic burning, so sometimes they have to perform forced burn cycles when the vehicle is parked. This uses a ton of extra fuel and upsets the owner, who doesn’t understand why their vehicle is running at a fast idle by itself and has superheated exhaust pouring out the back. Some early light trucks actually caught their plastic rear bumpers on fire. | ||
- | These chambers also get plugged up easily, [[https:// | + | These chambers also get plugged up easily, [[https:// |
- | To top it off, some early light diesels did a terrible job integrating the extra fuel delivery required - instead of adding an extra injector, they just cheaped out and had the last injector in the engine shoot extra fuel during the exhaust stroke, which caused internal engine issues (The 6.4L V-8 used in the [[rv: | + | To top it off, some early light diesels did a terrible job integrating the extra fuel delivery required - instead of adding an extra injector, they cheaped out and had the last injector in the engine shoot extra fuel during the exhaust stroke, which caused internal engine issues (The 6.4L V-8 used in Ford trucks was a particularly egregious example of this). |
===== Fuel Injection | ===== Fuel Injection | ||
Line 53: | Line 56: | ||
Plus new fancy variable-scroll turbos are problematic in lightly loaded applications, | Plus new fancy variable-scroll turbos are problematic in lightly loaded applications, | ||
- | On top of all these myriad issues, the Marketing departments realized that diesel engines had gotten an almost godlike mythos around them among the crowd of light-truck buyers to the point where they'd easily shell out another $5,000+ on top of the top-end gas engines for a diesel. This resulted in an escalating horsepower war between all the major manufactures (especially in the light pickup truck segment), but designing a low-revving diesel to make a ton of horsepower makes materials/ | + | On top of this myriad |
===== Looking forward | ===== Looking forward | ||
- | Over time as manufactures have figured out what works/ | + | Over time as manufactures have figured out what works/ |
+ | |||
+ | However for light-duty cycles such as seen in vans and consumer-oriented trucks, we can expect to see manufacturers realizing that diesels no longer make sense outside of perhaps the largest 1+ ton trucks. |