User Tools

Site Tools


electrical:12v:alt_and_solar

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
electrical:12v:alt_and_solar [2022/07/16 11:27]
frater_secessus [Augmented solar charging]
electrical:12v:alt_and_solar [2023/08/23 14:10] (current)
frater_secessus
Line 1: Line 1:
-Note:  although this page was written with alternator-augmented solar charging in mind, the general principles also apply to solar+[[electrical:shore_power|shore power charging]] and solar+[[electrical:generator|generator]] charging. +Note:  although this page was written with alternator-augmented solar charging in mind, the general principles also apply to solar+[[electrical:shore_power|shore power charging]] and solar+[[electrical:generator|generator]] charging. Also see [[electrical:12v:power_mix|Deciding on a Power Mix]]. 
 + 
 + 
 +> Solar and DC-DC alternator charging are going to be the best practices for maintaining charge in one's battery bank. It only requires a little math, a little discipline to stick with the math, and the right expectations about solar intake.  -- CMDR_Schrodinger((https://www.reddit.com/r/vandwellers/comments/15z8eh6/energy_management_during_trips/jxfv03f/))
  
  
-[[lifestyle:words_of_wisdom|Words of wisdom]]: "Bulk charging requires //current//. Absorption requires //relatively high voltage// and //time at that voltage//." - secessus 
  
 ====== Augmented solar charging ====== ====== Augmented solar charging ======
Line 15: Line 17:
 Solar works anytime there is available sunlight, not just when the vehicle is running.  Solar works anytime there is available sunlight, not just when the vehicle is running. 
  
-Alt charging alone is unlikely to get lead-acid chemistries fully charged since Absorption can take hours and alternators often cannot hold [[electrical:solar:charge_controller_setpoints|the required voltage]]. Incomplete charge ([[electrical:12v:psoc|Partial State of Charge]], or PSOC) over time will result in [[electrical:batterycide|battery murder]].   +Solar can meet both the **voltage** and **time** requirements necessary for [[electrical:12v:charging|complete charging]];  this is critical with lead-acid chemistries which will otherwise suffer damage from [[electrical:12v:psoc|partial states of charge]].  
  
 How to avoid (or attenuate) battery murder with this scenario: How to avoid (or attenuate) battery murder with this scenario:
   * get access to shore power every couple of days to get the bank fully charged.  This will retard the murderification process; or   * get access to shore power every couple of days to get the bank fully charged.  This will retard the murderification process; or
   * use a different (and $$$) battery alternative like LiFePO4 (no problems with PSOC) or carbon foam (needs full charge every couple of weeks?); or   * use a different (and $$$) battery alternative like LiFePO4 (no problems with PSOC) or carbon foam (needs full charge every couple of weeks?); or
-  * add in a small amount of solar.  +  * add in a small amount of solar <-- what this article is about
  
  
Line 27: Line 29:
 From ~80% to 100% (Absorption stage) charging requires little current but a long time holding at a relatively high voltage.  So in our alt+solar scenario the alternator does the heavy lifting in the beginning then a small solar install does the light (but lengthy) work at the end.((The solar will also contribute during Bulk when the sun is shining.)) From ~80% to 100% (Absorption stage) charging requires little current but a long time holding at a relatively high voltage.  So in our alt+solar scenario the alternator does the heavy lifting in the beginning then a small solar install does the light (but lengthy) work at the end.((The solar will also contribute during Bulk when the sun is shining.))
  
-Having a bit of solar may mean you can us a simpler/cheaper isolator rather than a more $$ [[electrical:12v:b2b|DC-DC charger]]. +Having a bit of solar may mean you can use a simpler/cheaper combiner rather than a more $$ [[electrical:12v:b2b|DC-DC charger]].
  
 ===== how alternator charging helps ===== ===== how alternator charging helps =====
  
 +Alternator charging is extremely powerful and cheap compared to typical solar installs.  It works best when solar works worst:  when the batteries are deeply discharged in the morning.  The sun is weak then but the bank needs a large supply of current (early [[electrical:12v:charging#bulk_stage|Bulk charging]]).  
  
-Solar power is relatively weak and expensive((for the amount of power produced)) compared to alternator charging.  Solar is most challenged in the morning when the bank is deeply discharged.  The sun is weak then but the bank needs a large supply of current (early [[electrical:12v:charging#bulk_stage|Bulk charging]]).  +[[electrical:solar:charge_controller#pwm|PWM]] controllers are especially hamstrung in this scenario;  since they run the panels at battery voltage (Vbatt) they produce the least power exactly when the most power is required.  By the time alternator voltage (Valtis reached PWM controllers are able to produce meaningful power.
  
-[[electrical:solar:charge_controller#pwm|PWM]] controllers are especially hamstrung in this scenario;  since they run the panels at battery voltage (Vbatt) they produce the least power exactly when the most power is required.  By the time Valt is reached PWM controllers are able to produce meaningful power. +Alt charging shovels current into the bank until Valt is reached, at which point it begins to taper off.  Solar can take it from there.  A good metaphor might be a two-stage rocket:  the alternator does the heavy lift getting the rocket off the ground then the solar charging takes care of the high altitude, high speed duties. 
- +
-Alt charging shovels current into the bank up to the point that alternator voltage (Valtis reached.  Solar can take it from there.  A good metaphor might be a two-stage rocket:  the alternator does the heavy lift getting the rocket off the ground then the solar charging takes care of the high altitude, high speed duties. +
  
 > Use a generator or alternator to get to 85% SOC or so early in the AM, then let Solar spend all day polishing off the last 15% because that takes time more than amps. - a64pilot((https://www.cruisersforum.com/forums/f14/time-it-takes-to-fully-charge-batteries-238875-9.html#post3223983)) > Use a generator or alternator to get to 85% SOC or so early in the AM, then let Solar spend all day polishing off the last 15% because that takes time more than amps. - a64pilot((https://www.cruisersforum.com/forums/f14/time-it-takes-to-fully-charge-batteries-238875-9.html#post3223983))
  
-===== when augmented charging works best =====+===== optimal alternator contribution =====
  
-Boosting solar charging with alternator, genny, etc, works best during bulk stage.  This is true for alternators because their terminal voltage is rather low, and for both generators and alternators because Absorption stage takes little current and a great deal of time.((particularly true for lead, although lithium charging voltages <3.5vpc typically require some Absorption time to get to a given SoC)) +Broadly speaking, //alternator charging is most effective in the morning// and //solar charging is most effective at local solar noon//.  This pattern is most evident when using isolators/relays and/or lead chemistry batteries, and less evident when using [[electrical:12v:b2b|DC-DC chargers]] and/or lithium chemistries.
  
-With generators, most efficient use will be when banks are [[electrical:depth_of_discharge|deeply discharged]], as the genny will run closer to its rated power.  **Generator charging would cease** when Absorption voltage is attained and current has fallen off to a point solar can handle it.  **Alternator charging would cease** when house battery voltage reaches alternator voltage; once solar takes the voltage higher than the alternator puts out the alternator is no longer contributing.   +There are several factors in play here.  
  
 +
 +==== charging stage ====
 +
 +During [[electrical:12v:charging#bulk_stage|Bulk charging stage]] the bank will accept maximum current.((by definition))  For most 'dwellers alternator charging current will outstrip solar charging current, making alternator charging most helpful during bulk.  //Bulk typically coincides with early morning.//  
 +
 +==== voltage delta ====
 +
 +Current varies proportionally with the difference ("delta") between the //charging voltage// and the //battery bank voltage// (Vbatt).  So lower Vbatt and/or higher charger voltage means higher current,((assuming the charging source can provide it and bank accept it)), which  means more Ah/Wh replaced in a given amount of time. 
 +
 +=== battery voltage ===
 +
 +Vbatt is most likely to be lowest **in the morning**, when the bank is most depleted.
 +
 +
 +=== charger voltage ===
 +
 +The device used for alternator charging affects the charging voltage side of the equation:
 +
 +  * [[electrical:12v:b2b|DC-DC chargers]]((and solar charge controllers and converter/chargers run off generator, see below)) typically have the highest charging voltages.  Example:  14.4v
 +  * Isolators/solenoids pass through alternator voltage.  Example:  14.2v
 +  * [[electrical:12v:alternator#solid_state_isolatorfet-based|FET-based isolators]] typically pass 0.1v less than alternator voltage.  Example: 14.1v
 +  * [[electrical:12v:alternator#solid_state_isolatordiode-based|Diode-based isolators]] typically pass 0.5v less than alternator voltage.  Example:  13.7v
 +
 +If we  stipulate our discharged bank is sitting at 12.2v then the voltage delta could be anywhere from 2.2v to 1.5v.  It doesn't sound like much, but all other things being equal +2.2v charging will result in **~47% more current** than +1.5v charging.((one can use this to [[electrical:12v:directcharginglfp#tweaking_current_with_voltage|limit charging current without a DC-DC]]))
 +
 +Since the output of solar charge controllers is relatively high (typically the same setpoints as the DC-DC charger), **the ability of an isolator to contribute current is reduced as solar harvest comes into play**.  
 +
 +
 +==== PWM solar charge controllers ====
 +
 +Getting bank voltage up earlier will also keep PWM solar charge controllers from getting [[electrical:solar:pwm_tweaking#pwm_s_achilles_heel|hamstrung due to low Vbatt]].  MPPT controllers are not affected by Vbatt.
 +
 +==== putting it all together ====
 +
 +Alternator((or generator)) charging is most helpful/efficient((Ah replaced for a  given amount of engine runtime)) in the morning when the bank voltage and state of charge are lowest.  This may mean shifting driving errands to mornings or rainy days.
 +
 +
 +
 +If an engine is running solely to charge the bank (idling, or running a generator) optimal use may mean running them through Bulk and early Absorption.  Engine charging would cease when Absorption voltage is attained and //current has fallen off to a point solar can handle it//.
 ===== augmented charging with lithium ===== ===== augmented charging with lithium =====
  
-Solar + alternator charging lithium is a bit simpler, and is centered on state of charge.((with lead batts it's both about state of charge and stage of health)).+Solar + alternator charging lithium is a bit simpler, and is centered on state of charge.((with lead batts it's both about state of charge and state of health)).  It is still most effective to charge with alternator in the morning, but the importance is lessened because: 
 + 
 +  - the Li voltage curve is very flat in the middle, so the voltage delta will be stable through the "middle 80%" 
 +  - for average users, Li will not have an Absorption stage in the lead-chemistry sense.((advanced users may find [[electrical:12v:drop-in_lifepo4#mythlithium_doesn_t_need_absorption|exceptions]] to this general statement)) 
 +  - Lithium is often charged with DC-DC, which charges at the ~same voltage as solar
  
    
Line 59: Line 103:
 If overvoltage is a concern, one can use one of these workarounds: If overvoltage is a concern, one can use one of these workarounds:
  
-  * disable automatic [[electrical:12v:charging#equalization|Equalization]] (EQ); or +  * disable automatic [[electrical:12v:charging#equalization|Equalization]] (EQ); and/or 
-  * decrease EQ voltage((Vequal))/duration; or+  * decrease EQ voltage((Vequal))/duration; and/or 
 +  * charge the house bank at the lower end of the Vabs spec; and/or
   *  [[electrical:12v:alternator_charging_hvd|automatically disconnect alternator charging]] when house battery voltage rises beyond the starter battery's preferred charging voltage.   *  [[electrical:12v:alternator_charging_hvd|automatically disconnect alternator charging]] when house battery voltage rises beyond the starter battery's preferred charging voltage.
  
electrical/12v/alt_and_solar.1657985247.txt.gz · Last modified: 2022/07/16 11:27 by frater_secessus