User Tools
electrical:12v:b2b
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
electrical:12v:b2b [2021/06/18 18:56] frater_secessus [further reading] |
electrical:12v:b2b [2021/06/21 15:07] frater_secessus [Kisae] |
||
|---|---|---|---|
| Line 129: | Line 129: | ||
| When the alternator input terminals detect at least 13.2v the charger will be switched to alternator charging.((trigger wire allows use of smart alternators)) | When the alternator input terminals detect at least 13.2v the charger will be switched to alternator charging.((trigger wire allows use of smart alternators)) | ||
| + | ==== Redarc ==== | ||
| + | |||
| + | [[https:// | ||
| + | |||
| + | * [[https:// | ||
| + | * [[https:// | ||
| + | |||
| + | The Redarcs appear to do both buck and boost; | ||
| + | |||
| + | |||
| + | |||
| + | === solar+alternator behavior === | ||
| + | > The unit will always take as much power from the unregulated Solar input as it | ||
| + | can before supplementing that power, up to the maximum rated output, from Vehicle power input((https:// | ||
| Line 184: | Line 198: | ||
| Observe voltage input maximums on units with built-in solar charge controllers. | Observe voltage input maximums on units with built-in solar charge controllers. | ||
| - | Voltage-sensing units((triggered by elevated chassis voltage)) can misbehave when an undersized starter battery charger/ | + | Voltage-sensing units((triggered by elevated chassis voltage)) can misbehave when an undersized starter battery charger/ |
| - starter battery voltage rises from 10A maintainer charging... | - starter battery voltage rises from 10A maintainer charging... | ||
electrical/12v/b2b.txt ยท Last modified: 2024/05/17 11:40 by frater_secessus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
