RV and vandwellers wiki

User Tools

Site Tools

Trace:
electrical:12v:lvd

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
electrical:12v:lvd [2021/10/04 12:29]
frater_secessus [Low Voltage Disconnect (LVD)] 		electrical:12v:lvd [2023/09/06 10:53]
frater_secessus [Low Voltage Disconnect (LVD)]
Line 3: Line 3:
 A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage (Vlvd). A low voltage disconnect is used to stop loads from dragging a battery bank below a given voltage (Vlvd).
  
-In theory the simplest way to implement an LVD would be to wire all loads go through the [[electrical:solar:charge_controller#using_load_output|LOAD output]] of the charge controller, and set the controller's Vlvd.  In practice this is rarely done for reasons given in the link above.  It is more common to run a [[electrical:12v:relay|relay]] on the LOAD output, which is triggered ON/OFF by the LVD setting.((the LOAD triggers the relay, but actual power comes from the battery bank))  + 
 +===== examples ===== 
 + 
 +[[https://amzn.to/3Ri94RY|{{ https://m.media-amazon.com/images/I/51ODnDvz-rL._AC_UL400_.jpg?125}}]] 
 + 
 +* [[https://amzn.to/3Ri94RY|Victron Battery Protect]] 
 +* [[https://amzn.to/47Xzz5n|Blue Sea 7635 m-LVD]] 
 +* [[https://www.amazon.com/s?k=low+voltage+disconnect&link_code=qs&tag=themousepad|various amazon listings]] 
 + 
 +One can also **DIY a low voltage disconnect**.   
 + 
 +In theory the simplest way to implement an LVD would be to wire all loads go through the [[electrical:solar:charge_controller#using_load_output|LOAD output]] of the charge controller, and set the controller's [[electrical:solar:charge_controller_setpoints|Vlvd]].  In practice this is rarely done for reasons given in the link above.  It is more common to run a [[electrical:12v:relay|relay]] on the LOAD output, which is triggered ON/OFF by the LVD setting: 
 + 
 +controller LOAD output -> relay -> loads((the LOAD triggers the relay, but actual power comes from the battery bank))  
  
 If the controller has no LVD (or not no LOAD output at all) you can use a   [[https://amzn.to/3m2OTp3|stand-alone LVD]] powered by the battery.  If the controller has no LVD (or not no LOAD output at all) you can use a   [[https://amzn.to/3m2OTp3|stand-alone LVD]] powered by the battery. 
electrical/12v/lvd.txt · Last modified: 2023/09/06 10:54 by frater_secessus

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International

affilliate disclosure

CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki