User Tools

Site Tools


electrical:12v:wallwart

This is an old revision of the document!


Devices with power adapters

It is a common misconception that inverters are needed for everything that plugs into a wall. Inverters are generally required only for devices that run off wall power with cord that runs permanently into the device. Example: table lamp.

ae01.alicdn.com_kf_htb1znnnlxxxxxbyxpxxq6xxfxxxd_12v-2a-eu-plug-ac-adapter-dc-power-supply-plug-euro-regulation-wall-wart-charger-5.jpgDevices that have a “wall-wart” power adapter that can disconnect from the device are typically using DC power, which is what is already in your car. No inverter needed. The adapter is there only to change 120vac to the required amount of DC voltage.1)

How to decide: If you need an inverter for other reasons it is often reasonable to run DC adapters from that inverter.2) It is rarely reasonable to buy an inverter solely to run DC adapters.

common device voltages

19vdc

19vdc is the modern standard for charging laptops. You can buy a 12vdc –> 19vdc adapter as an accessory from your laptop manufacturer or buy a generic one with various plugs.

12vdc

The car's own power system (and likely your aux power system) is already 12v. So if the device runs off 12v you can power it directly off power system: 12vdc –> device. If you did it from an inverter instead you'd be going 12vdc (car) –> 120vac (inverter) –> 12vdc (adapter) device, with added complexity, inefficiency and cost.

5vdc

images-na.ssl-images-amazon.com_images_i_41theiafxsl._sy90_.jpg5vdc is most often seen in USB. If your device needs 5v3) you can likely run it from a USB to plug adapter. Example. You will have to assess the plug size.

other voltages

Other voltages like 9v and 6v are less common. If you have multiple devices that use the same odd voltage you might want to buy a DC-DC buck converter and adjust it for the desired voltage.

Inexpensive ones (example) typically have a “pot” (screw to turn on a potentiometer) to adjust voltage, so bring your multimeter. They are so inexpensive you might keep a few pre-tuned and labeled for specific voltages.

Fancier ones (example) might have LED readouts and allow you to configure the output with buttons.

If you have an adapter with a weird output voltage and don't want to mess with buck converters a very small, inexpensive inverter might be the thing. Even one small enough to run from the cigarette lighter (example).

1)
ie, “rectification”
2)
Exception: really big inverters with high parasitic loads running small adaptes
3)
up to ~2A
electrical/12v/wallwart.1619995238.txt.gz · Last modified: 2021/05/02 18:40 by frater_secessus