User Tools

Site Tools


electrical:solar:sizing

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
electrical:solar:sizing [2022/01/15 03:10]
princess_fluffypants [voltage]
electrical:solar:sizing [2023/08/31 19:54] (current)
princess_fluffypants [Voltage]
Line 70: Line 70:
 ==== calculators ==== ==== calculators ====
  
 +  * Unbound Solar [[https://unboundsolar.com/solar-information/offgrid-calculator|offgrid calculator]]
 +  * AltE [[https://www.altestore.com/store/calculators/off_grid_calculator/|offgrid calculator]]
   * [[https://www.batterystuff.com/kb/tools/calculator-sizing-a-battery-to-a-load.html|BatteryStuff 12v load calculator]]   * [[https://www.batterystuff.com/kb/tools/calculator-sizing-a-battery-to-a-load.html|BatteryStuff 12v load calculator]]
   * [[http://gpelectric.com/tools/GoPowerCalculator.htm?state=RvDiv|GoPower calculator]]   * [[http://gpelectric.com/tools/GoPowerCalculator.htm?state=RvDiv|GoPower calculator]]
Line 137: Line 139:
  
 Most camper solar installs run at [[electrical:12v:electrical_notation|nominal]] [[electrical:12v:intro|12v]].  Because of this most accessories are 12v.   Most camper solar installs run at [[electrical:12v:electrical_notation|nominal]] [[electrical:12v:intro|12v]].  Because of this most accessories are 12v.  
 +
 +Some installations utilize 24v electrical systems. This is common in boats, and occasionally some very large commercial RVs.  The common theme of an advantage to 24v is that you're using half the amperage to transfer the same amount of power, which can result in cheaper components
  
 You may want to consider running a 24v system if: You may want to consider running a 24v system if:
-    * your panels are rated at 600w or higher - Ohm's law tells us that 600w / 12v = 50A but 600w / 24v = 25A.  A 24v system can use much smaller/cheaper charge controller and small/cheaper wiring to handle the same amount of power. +    * You have a //lot// of solar, like 600w or more. 
-    * the run from panels to charge controller is lengthy  +      * Ohm's law tells us that 600w / 12v = 50A but 600w / 24v = 25A.  Therefor, you can use much smaller (and cheaperwiring to connect your solar panels to the charge controllor  
-    * you will be using inverters heavily - inversion from 24vdc to 110vac is more efficient than inversion from 12vdc.+    * You will be using inverters heavily 
 +      * Inversion from 24vdc to 110vac is more efficient than inversion from 12vdc. 
 +    * You have large, power-hungry appliances that can run natively off of 24v 
 +      * Some [[food:refrigeration|DC refrigerators]] and induction cooktops can run off of both 12v or 24v, and are slightly more efficient when running off of 24v. 
 +      * [[hvac:solar_ac|Off-grid Air Conditioning]] can be slightly more efficient with 24v native systems, and will allow smaller wires to be used. 
 +    * You have a lot of long, large cable runs 
 +      * 24v doesn't have as much voltage drop as 12v over a similar distance, and can use smaller/cheaper cables. 
 +    * A 24v system can use a much smaller/cheaper charge controller
  
-There are downsides to 24v, however.  There are fewer 24v accessories, and you cannot use a chassis ground as it is already grounded to the coach's 12v system.+There are downsides to 24v, however.  There are fewer 24v accessories, and you cannot use a chassis ground as it is already grounded to the coach's 12v system.  It can also make alternator charging difficult, as [[https://www.amazon.com/Hyuduo-Converter-Voltage-Regulator-Stabilizer/dp/B07NM52VV5|DC-DC boost converters]] get quite expensive when they are sized to handle the required loads.
  
  
Line 149: Line 160:
 ===== solar panel array ===== ===== solar panel array =====
  
-Pick a solar panel array output on battery bank capacity.  A common **rule of thumb for matching panels to battery bank** is that there should be **at least** 1 panel watt per amp-hour of nominal bank capacity.  +Pick a solar panel array output on daily power requirements and  battery bank capacity.  A common **rule of thumb for matching panels to battery bank** is that //at a minimum// there should be 1 panel watt per amp-hour of nominal bank capacity.  
  
 > "...the person draining their batteries to the 50% range regularly would do much better with a 2 watts to 1Ah ratio, or even 3 to 1." -- SternWake((http://www.cheaprvliving.com/forums/Thread-How-much-solar-do-I-need?pid=278438#pid278438)) > "...the person draining their batteries to the 50% range regularly would do much better with a 2 watts to 1Ah ratio, or even 3 to 1." -- SternWake((http://www.cheaprvliving.com/forums/Thread-How-much-solar-do-I-need?pid=278438#pid278438))
electrical/solar/sizing.1642234211.txt.gz · Last modified: 2022/01/15 03:10 by princess_fluffypants