Differences

This shows you the differences between two versions of the page.

--- electrical:solar:tracer [2022/02/26 15:49]
frater_secessus [quirks]
+++ electrical:solar:tracer [2022/03/02 13:48]
frater_secessus [MT-50 display] bau rate
@@ Line 22: / Line 22: @@
 ===== quirks =====
-Some [[electrical:solar:charge_controller_setpoints|voltage setpoints]] are constrained in relationship to each other.   Because of this it may be easiest to write them out in this order((http://techluck.com/cgi-bin/YaBB.pl?num=1486955008)) to make sure the logic below is followed.
+Some [[electrical:solar:charge_controller_setpoints|voltage setpoints]] are constrained in relationship to each other.   Because of this it may be easiest to write them down in this order((http://techluck.com/cgi-bin/YaBB.pl?num=1486955008)) (lowest to highest voltage) to make sure the logic below is followed.  Then program them into the controller.
   - "Low Voltage Reconnect Voltage" (load)((reconnect loads after regaining this voltage))
@@ Line 154: / Line 154: @@
 Because of a tweak Renogy made to their version of the controllers, the plain MT-50 will not work and you must pay extra for [[https://amzn.to/2YueTzP|the Renogy MT-50]].
+Note:  some comms problems can be solved by [[https://www.reddit.com/r/SolarDIY/comments/t4xydv/fixing_an_epever_tracer_4210an_charge_controller/|adjusting the baud rate]].
 ==== MT-75 display ====

RV and vandwellers wiki