This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
opinion:frater_secessus:panelsizesforinsolation [2022/05/08 10:44] frater_secessus [Solar panel sizing for different geographical areas] |
opinion:frater_secessus:panelsizesforinsolation [2022/07/20 16:40] frater_secessus [Amount of solar wattage required per 100Ah of Pb] further reading |
||
---|---|---|---|
Line 15: | Line 15: | ||
Historical weather info is also used to calculate FSE, so good/bad weather is already baked into the average. | Historical weather info is also used to calculate FSE, so good/bad weather is already baked into the average. | ||
- | Ambient temperatures also affect panel output, and that is silently factored into the bottom table. | + | |
Line 56: | Line 56: | ||
Assumptions: | Assumptions: | ||
+ | * panel output is temperature-derated according to daily average high at each time/place | ||
* **no other loads** other than charging are present | * **no other loads** other than charging are present | ||
* AGM deep cycle battery is discharged to [[electrical: | * AGM deep cycle battery is discharged to [[electrical: | ||
Line 66: | Line 67: | ||
* solar-only charging the same number of amps into lithium would require about 10% less panel than AGM due to better charging efficiency. | * solar-only charging the same number of amps into lithium would require about 10% less panel than AGM due to better charging efficiency. | ||
+ | ===== further reading ===== | ||
+ | |||
+ | * factors affecting [[electrical: |