This is an old revision of the document!

DIP switches on Renogy DC-DC chargers

TL;DR

the DIP configuration tables and nomenclature in the 20-40A-60A DCC1212 series manual are needlessly confusing. The tables below intend to correct that
the DIP switch area has indicator that shows ON↓. Pay close attention to this, especially if the charger is mounted and you are looking at it from an odd angle.
in the tables below, lithium (Li) profiles effectively means “floatless” and lead (Pb) means “with Float stage”. It is possible to define a quasi-Float for LiFePO4 using a “lead” profile; see below.

Li Boost voltage	SW1	SW2	SW3	SW4	SW5
LiFePO4 14.0v	OFF	OFF	ON	ON	OFF
LiFePO4 14.2v	ON	OFF	ON	ON	OFF
LiFePO4 14.4v	OFF	ON	ON	ON	OFF
LiFePO4 14.6v¹⁾	ON	ON	ON	ON	OFF

12.6v²⁾	OFF	OFF	OFF	OFF	OFF
12.8v	OFF	OFF	ON	OFF	OFF
13.0v	OFF	OFF	OFF	ON	OFF

Pb Boost voltage	SW1	SW2	SW5
14.1v³⁾	OFF	ON	ON
14.4v⁴⁾	ON	ON	ON
14.7v⁵⁾	OFF	OFF	ON

Pb Float voltage	SW3	SW4	SW5
13.2v	ON	OFF	ON
13.5v	OFF	ON	ON
13.8v	ON	ON	ON

There are reasons for and against "floating" lithium.

If you

¹⁾

not recommended - secessus

²⁾

3S Li-NMC, for example

³⁾

gel?

⁴⁾

AGM?

⁵⁾

flooded?